Thanks all!
Of course, I'm going to cover a shell surface with armer panels and block large gaps between her hull and the shell with armer panels, but their dimensions and patterns are not decided yet. As you know, panel modeling is boring but very important to define vessel's character. I hope that modeling would be finished by the end of March.
Firstly, I planned to name her and her sisters after giants and giantesses in Norse myth, so one of them may have been named "Skadi".
Currently I assigned "Arvak" and "Alsvid" to gunstar, "Sleipnir" to a special type battlestar, "Skinfaxi" and "Gullfaxi" to standard battlestar and "Grani" to strikestar(battlestar variant covered with two shells). All names are those of horses in Norse myth.
Dimensions of Skinfaxi were defined based on Valkyrie, whose length was assumed about 1200m. As shown in the attached image, dimensions of front part are quite similar to Valk. Cannons were copied from my GALACTICA's mesh. Their sizes were estimated from GALACTICA's image by ZOIC, but it may be somewhat small...?
