Challenge #9 - Cylyndrical Carrier

[grexx]

I have never done one of these challenges before so I hope I followed the directions right.

I started with a cylinder and cut my poly lines, extruded, intruded, ect. I added gun turrets to it that are each separately modelled (it needs defense). The Island and command center are all extrusions from the original cylinder.

I added the texture maps, lighting, fighter screens, and an escort cruiser above a nebula for the final pic.

[grexx]

Ok here are the last 2 pictures. I added texture maps, lights, fighters, an escort cruiser, and a starfield / nebula for the final pic. I also put gun turrets on the carrier for defense that were modelled separately.


Thanks to scifi-meshes for holding the contest. It was fun trying to rise to a challenge and very interesting to see all the ideas everyone came up with for this event.


I just hope I did this right.

[fluxfire]

Coo very unusual design i like that.....

[Ozylot]

Very interesting design! I like that it is asymmetrical. Although I think it could use a bit more segments on the curved sections. Cool design though.